triocolour.blogg.se - Altra usb blaster drivers windows 10

#Altra usb blaster drivers windows 10 serial#
#Altra usb blaster drivers windows 10 update#
#Altra usb blaster drivers windows 10 driver#

Select Browse my computer for driver software.

#Altra usb blaster drivers windows 10 update#

Right mouse click on this and then select Update Driver Software…

Under Other devices, USB Blaster should be listed.

Open the Device Manager (Windows Key | Control Panel | Device Manage).

Now cancel this (probably by selecting Cancel).

The following will appear on the screen: Device driver software was not successfully install.

Plug the USB-Blaster download cable into the PC.

If the Windows security window pops up Check the Always trust software from “Altera Corporation”box and select Install.įor Windows 7 and Windows 8, do the following:.

Make sure the proper path was selected then select Next.

(Note 2: Stop at the drivers folder, i.e., do NOT go deeper by opening a folder within the drivers folder).

The location listed in this document is the default location)

(Note 1: Your altera file is located at the location you selected when you first installed quartus.

Select Browse my computer for driver software.

Again a new window should pop up with the General tab already selected.

A new window should pop up with the General tab already selected.

Select the Hardware tab and select Properties.

Right mouse click on this and then select Properties.

Under Unspecified, USB Blaster should be listed.

Open the Device and Printers (Control Panel | Devices and Printers).

2 For Windows 7 and Windows 8, do the following:.

The figure 1, 2,and 3 below shows the header pinouts of different interfaces.

Target board connection via JTAG, AS, PS interfaces.

Computer connection via USB 2.0 interface.

Enhanced Configuration Devices including: EPC1, EPC4 etc.

#Altra usb blaster drivers windows 10 serial#

Active Serial Configuration Devices including: EPCS1, EPCS4, EPCS16 etc.FPGA: Stratix, Stratix II, Cyclone, Cyclone II, CycloneIII, ACEX 1K, APEX 20K and FLEX 10K etc.Tested devices are listed below, including but not limited to: NIOS II EDS integrated development environment.NIOS II IDE integrated development environment.Quartus II integrated development environment.Supports Nios II of embedded processor communication and debugging.Supports SignalTap II embedded logic analyzer.High-speed, stable, and internal FT245R+CPLD designed.Supports AS, PS, JTAG three download modes.Supports most of the ALTERA FPGA/CPLD devices, Active Serial Configuration devices, and Enhanced Configuration Devices.

Download speed 1-3 times faster than other schemes, such as 68013 or C8051F.High speed FT245+CPLD+244 solution, similar download speed as the original ALTERA USB Blaster, with the same operation.It surpports most of the ALTERA FPGA/CPLD devices, Active Serial Configuration devices, Enhanced Configuration devices, and supports AS, PS, JTAG three download modes. You can use the USB Blaster cable to iteratively download configuration data to a system during prototyping or to program data into the system during production. The cable sends configuration data from the PC to a standard 10-pin header connected to the FPGA. The USB Blaster Download Cable interfaces a USB port on a host computer to an Altera® FPGA mounted on a printed circuit board. USB Blaster Download Cable is designed for ALTERA FPGA, CPLD, Active Serial Configuration Devices and Enhanced Configuration Devices, USB 2.0 connection to the PC and JTAG, AS, PS to the target device. Speech / Image Recognition / AI Cameras.